Tea Moisture Content and How to Test Black and Green Tea
By Lim Xu, Export Manager
Tea moisture content is checked by an oven loss-on-drying method, then often by a halogen moisture analyzer. See how to test black and green tea.
Tea moisture content is the mass the leaf loses when it is dried under a stated method, not a loose idea of how dry the tea feels. The usual reference is an oven method. A halogen moisture analyzer is used for faster routine checks once it has been compared with that reference.
Why tea moisture is controlled
Moisture affects how tea stores, how it travels, and how a lot is valued. Leaf that is too wet can spoil or cake. Leaf that is over-dried can lose quality and weight that the seller would rather keep.
The same concern applies to black tea and green tea, and to broken grades and powders as well as whole leaf. The limit you work to should come from the contract or the specification, not from a generic figure in an article.
ISO 3720 sets out a definition and basic requirements for black tea, including chemical requirements used to indicate good production practice. The public abstract does not give a moisture cap, so this article does not quote one. If your specification names a limit, use that limit and the method it points to.
Reference method ISO 1573
ISO 1573 is the official method titled "Tea - Determination of loss in mass at 103 degrees C." The official abstract describes heating a test portion in an oven at 103 °C ± 2 °C, to constant mass.
That result is a loss on drying, not a water-specific assay. Other volatiles can be included in the loss, which is why the report should name the method, the temperature and the endpoint.
For instant tea in solid form, ISO 7513 is a related loss-in-mass method at the same oven temperature. Do not mix an instant-tea result with a leaf result without saying so.
An NPL review of loss-on-drying methods treats oven drying as a fundamental method that does not, by itself, need a secondary calibration. A halogen analyzer is faster, but it has to be checked against the oven method on the same tea.
Not sure how your tea will behave on a halogen analyzer? Tell us what you need to test. We test a similar material sample and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
Halogen analyzer settings for tea
A halogen moisture analyzer weighs a sample, dries it under a halogen lamp, and reports moisture from the loss in mass. The temperature and the endpoint decide how close that figure comes to the ISO 1573 oven result.
A first trial point for tea is the oven temperature in ISO 1573, 103 °C. The setting you keep should come from a comparison on your own leaf, not from copying the oven value blindly. Our guide to halogen moisture analyzer temperature settings explains how to run that check.
The halogen moisture analyzer we offer has a set temperature range of 40 to 160 °C in 1 °C steps, which includes that oven trial point. A datasheet can be requested from KHT if you need the full specification. Confirm the program with us if you are matching a named tea method.
The endpoint matters as much as the temperature. If the analyzer stops too soon, water remains and the result is low. If it runs on after the leaf has started to scorch, the result is high. Use a constant-mass or a low-rate-of-change endpoint, and inspect the residue for charring.
Leaf, broken and powder samples
Whole leaf, broken grades and powder do not dry at the same rate. A piled whole leaf hides moisture in the centre of the pan. A fine powder dries faster and can blow or crust if the program is too hard.
Spread a representative portion in a thin, even layer. Do not heap the leaf against the pan wall. If the specification requires a ground sample, grind it the same way every time, because grinding changes the surface and the loss.
Keep the time from opening the pack to starting the test short and consistent. Tea left on the bench can pick up or lose moisture before the first weighing.
Black tea and green tea can be run on the same analyzer, but they should have their own comparison against the oven method. A program that matches ISO 1573 on one tea may drift on the other if the leaf size or the process is different.
For a wider view of how a halogen result is compared with an oven method, see our article on a moisture analyzer for grains. Use it for the comparison idea, not as a program to copy onto tea.
Storage and re-testing
After drying or after a shipment, tea can take up moisture again from the air. Store retained samples in closed containers, and do not treat an old, open tin as a reference for a new lot.
If you re-test a lot, use the same preparation, the same program and, if you can, the same analyzer. A change in grind or pan loading is enough to move the result.
The comparison idea is the same as in other oven-versus-analyzer work; the oven method and the sample preparation are not, so do not copy a grain program onto tea.
Frequently asked questions
Can a halogen analyzer replace ISO 1573 for official results?
Only if your specification allows it, and only after you have compared the analyzer with the oven method on your own tea. Until then, treat the halogen result as a routine check and keep ISO 1573 as the reference.
Do black tea and green tea use the same program?
They can start from the same oven trial temperature, but each type should have its own comparison with ISO 1573. Leaf size and process differences are enough to justify a separate check.
Does a test video replace a quotation?
No. The video shows the method on a similar material sample. For a quotation, tell us the teas you test, how many samples you run a day, and the method you check against.
Get a test video for your samples
Tell us what you need to test, such as the material, the size and the test method. We test a similar material sample on the instrument you are looking at and send you the video, so you do not need to ship a sample. If you prefer to send your own, we accept that too.
Questions about a model or a test? Email Amy Zhao, Export Manager, at [email protected].




